

















Cutting Implement 008
This cutting implement is symmetrically forged and ground for a either handed user. This small knife is a sturdy knife that would perform great field dressing a harvest or on the board chopping up veggies. edge is more robust than typically found on my knives but still plenty thin and sharpe enough to have a great cutting feel. The beech wood handle was sourced from scrap pallet would found at Thommy’s Back to Earth Natural Aged Mulch. With a black paper micarta ferrule this takedown style handle can be fully disassembled with a torx screw.
My knives are intended to be used daily in the kitchen and if for any reason they break under normal use I will repair or replace at no cost to the user. As these knives are extremely hard and thin they should be handled with the same care as a Japanese knife
Steel: Wolfram Special
HRC: 64 HRC calculated based on heat treating schedule and steel composition
Handle: recycled beach from Thommy’s , micarta ferrule, take down design
Edge Length: 75 mm (2.95”)
Thickness at Ricasso: 2.8mm (0.115”)
Thickness at Tip Break: 2.1 mm (0.081”)
Height at Heel: 40 mm (1.58”)
Handle Length: 120 mm (4.75”)
Balance Point: wood micarta interface
Weight: 124g
This cutting implement is symmetrically forged and ground for a either handed user. This small knife is a sturdy knife that would perform great field dressing a harvest or on the board chopping up veggies. edge is more robust than typically found on my knives but still plenty thin and sharpe enough to have a great cutting feel. The beech wood handle was sourced from scrap pallet would found at Thommy’s Back to Earth Natural Aged Mulch. With a black paper micarta ferrule this takedown style handle can be fully disassembled with a torx screw.
My knives are intended to be used daily in the kitchen and if for any reason they break under normal use I will repair or replace at no cost to the user. As these knives are extremely hard and thin they should be handled with the same care as a Japanese knife
Steel: Wolfram Special
HRC: 64 HRC calculated based on heat treating schedule and steel composition
Handle: recycled beach from Thommy’s , micarta ferrule, take down design
Edge Length: 75 mm (2.95”)
Thickness at Ricasso: 2.8mm (0.115”)
Thickness at Tip Break: 2.1 mm (0.081”)
Height at Heel: 40 mm (1.58”)
Handle Length: 120 mm (4.75”)
Balance Point: wood micarta interface
Weight: 124g